After the installation of the BLM 2000 System, the trained BLM 2000 installer will check for the correct operation using a pre-calibrated testing device.
For visual verification of the BLM 2000 operation, check the LEDs on the Control Unit. The red LED indicates that the System is powered. The blue LEDs indicate that the audio signal is being sent to each beer line. The blue LEDs should be flashing according to the installed configuration. Please refer to the BLM 2000 Operating Procedures to ensure that you understand which blue LEDs should be flashing in relation to the Transponders that have been connected.
Q5:
Do I need to clean the BLM 2000 System?
A5:
As the BLM 2000 is operating in an environment where beer may get spilt on the transponders from time to time, it is recommended to wipe the transponder surfaces with a damp cloth to remove any dried beer from the surface. The Control Unit should be mounted in a position whereby beer spillage should not occur, but a quick wipe with a damp cloth of the Control Unit certainly ensures minimal build-up of dust, etc.
